Safety in the Laboratory is a primary concern. The fume hoods meet the challenge high degree of efficiency. A wide variety of models and comprehensive op on packages have been designed to enable you to tailor your fume hood to a specification

• FUME HOOD MADE OF COMPLETE MILD STEEL

  • Are manufactured from best quality C.R.C.A. Sheets (Cold Rolled Case Annealed Low carbon steel sheets) of 18/20G which are duly epoxy polyester powder coated. Powder coating of this quality provides better protection from acid fumes in the lab.

• FUME HOOD MADE OF COMPLETE WOOD

  • Are manufactured from well seasoned teakwood and 12mm thick marine plywood panels. Outer surface are lined with laminates
  • Both Fumes Chamber: Are available with variety of lining and work surface like PP, PPGL, FRP, SS, (316), PVC, HDPE, suspended on suspended on safe device. It is provided with counter balance load for easy up and down movement * Are aerodynamically designed which provides most efficient airflow to the suction
  • Are double wall construction which provides easy maintenance, access to service like Water gas, electricity etc. Are provided with support base having provision for air vent connection to evacuate lapped chemical vapor inside. Are provided with switch for easy starting of the centrifugal fan. High quality HDPE/FRP/PPGL/PP/PVC pipes & accessories are used for FC during.
  • We are using centrifugal PP/FRP Blower for Exhaust system of FC, 3 Phase Motor (Capacity according to need) is coupled with blower